Fire Detection Systems
Nurse Call Systems
Attendant Call Systems
Disabled Call Systems
Emergency Evacuation Lighting
Linear Heat Detection and Location Detection Device
Signaline LocatorPlus is a revolutionary new controller and alarm locator for Signaline FT and Signaline FT-R range of linear heat detectors.
Housed in an IP66 enclosure the Signaline LocatorPlus is capable of monitoring 2 separate zones of Signaline FT or Signaline FT-R, with up to 3km of cable per zone. Signaline LocatorPlus will give exact alarm location, via its LCD display, of any over heat along either zone of cable.
It is compatible with either conventional or addressable fire systems via the alarm relay contacts and offers further connectivity via the MODBUS output.
The Signaline LocatorPlus also offers two operating functions; Independent or Interlocking mode. When set to Independent if either zone of cable alarms this is immediately reported via the relays to the control panel. Alternatively Interlocking will wait for both lines of cable to be in alarm before triggering the relays.
Signaline LocatorPlus is UL approved and can be integrated with a suitable barrier when the linear heat detection is to be used within a hazardous area.
Dimensions 180 x 120 x 60.5mm HxWxD IP Rating IP65 Finish Light Grey with clear lid Display 2 line, 16 character backlit display showing zone status Approvals UL 864 10th ed. Operating voltage 12-36Vdc Operating current <12mA <4mA Alarm current <40mA <15mA Operating temp. range -20°C – +50°C (-4°F – +122°F) Terminal blocks Spacing 5mm Rising Clamp Rating 16A Wire size 0.08mm2 (28AWG) to 4mm2 (11AWG) Supervised circuits Power, Input Zone 1 & Input Zone 2 Inputs Up to two zones of Signaline FT or FT-R Linear Heat Detection Zone length 1-3000m (10,000ft) End of Line resistor 1kohm (included) Short circuit current 0.5mA Max voltage 5V Ground fault impedance 0ohms Communications Two wire RS-485 Modbus RTU (field wiring limited to same room to comply with UL listing) Sounder 2.4kHz 92dBa @ 10cm Buzzer Alarm 2x Form C volt-free relay contacts (resistive, com-mon) Max V 30Vac or 42.4Vdc Max Current 2A Max Switching Power 60W, 62.5VA Fault 2x Optoisolated phototransistor output (resistive, common) Max V 35Vdc Max Current 80mA Max Power Dissipation 150mW
